BlueCast LS for Formlabs and SLA 3d printers
Castable: Yes - Castability: Good
Compatible with: Form1+ (castable v2) / Form2 (gray v2) / Asiga Pico 2 (fusiongray 0.025) / Moai / Dws (dc400) / b9 (emerald) e stampanti SLA (405 nm)
Washing mode: Ethyl / IPA alcohol 30 seconds _ Drying with compressed air
UV care: 60 min
Size: 500 gr
BLUECAST LS FOR FORMLABS 3DP
Tuned for Formlabs 3d printers and compatible with other SLA machines (405 nm).
Wery low shrinkage and High Accuracy
Suitable for filigree, micrò pave, stones settings and standard jewelry.
Minimal residue after burnout process (0.003%)
Low-exhaust emission during the burnout process
Virtually no expansion of resin during burnout process
Compatible with all investments (Tested with Kerr® Satincast, R&R PlastiCast, Optima Prestige, Omega Plus)
Washable with 90%/99% denatured alcohol (IPA) or ethyl alcohol 90%/99%.
Very low deformation during post-printing
Direct casting of models with no need for lacquer or Teflon® (PTFE) spray
High definition and smoothness of surfaces
Remarkable definition of micro-engrave and micro-reliefs