BlueCast Cr3a LCD
Cr3a is one of the easiest castable resins to print and ensure excellent casting. Differently from other monomer based resin that requires complex and tricky treatments our BC Cr3a just requires to be washed after print and cured in to BC CURING LIQUID we supply. No hot water wash required, no boiling, no overnight curing.
BLUECAST CR3A FOR LCD PRINTERS - 500 gr
- Consistent casting quality as BlueCast standard
- Ash residual 0.00% _ proprietary TGA at 750°C / 4 hrs without contact to air, in closed vessel
- Low cost - Negligible shrinkage
- No primer needed
- Monomer based resin (tested as not toxic / not carcinogenic)
- High resolution
- Good strength
- Fast printing speed
- Very low odor
- Very low viscosity, no need to heat
- Chromacure® will tell you when postcure is done and pattern is ready to cast